The Series SW-218 Switches are
Broadband, High Speed, Low Loss SPST Switches
With Integral Drivers. They are Powered by +5 and -15
Volt Supplies and are
Available Powered by ±15 Volts. They are Available in
Three Models that Operate
Over the Entire 0.5 to 18 GHz Band. Each Features Rugged
Integrated Circuit
Assemblies of Chip PIN on a Microstrip Transmission Line and
Proprietary Wideband
Bias Decoupling Circuitry. Switching is Accomplished by
a TTL Compatible Driver
Which is Controlled by the User.
Specifications:
|
0.5 – 18 GHz |
|
30 dB Minimum |
|
2.0 dB Maximum |
|
1.9:1 Maximum |
|
(10% – 90% RF) and (90% – 10% RF): 10 ns |
|
From 50% TTL to 90% RF for Turn-Off: 20 ns From 50% TTL to 10% RF for Turn-On: 20 ns |
|
Average: 2 Watts Peak 1 usec, Maximum, pw: 10 Watts |
|
+15 VDC: 100 mA + 5 VDC: 100 mA – 15 VDC: 45 mA |
|
TTL Compatible, Two Load. (A Load is 1.6 mA Sink Current and 40 uA Source Current.) |
|
Logic “0” (-0.3 to +0.7 Volt) for Switch Off. Logic “1” (+2.5 to +5.0 Volts) for Switch On. |
Available Options:
001 |
Two SMA Male RF Connectors |
|
One SMA Male and One SMA Female RF Connector |
|
Solder Type Control Terminals |
|
±15 Volt Power Supply Requirement (+5, -15 Volt is Standard) |
|
50 Ohm Control Impedance |
|
Cannon MultiPin MDM9SSP |
|
Inverted Logic |
|
Extend Frequency to 100 MHz |
|
50 ns Maximum Switching Speed (5 Watts CW Maximum) |
|
2 ns Maximum Switching Speed (100 mw CW Maximum) |
|
-12 VDC Power Supply Requirement |
|
Integral Video Filters (2-18 GHz Frequency Band) |
Environmental Ratings:
Our standard environmental ratings are as follows, for specific requirements please contact us… |
|||||||||||||
|
Outline Drawing:
Click here to see the Outline Drawing for
SW-2182-1A
Product Feature:
Click here to see the Product Feature for
SW-2182-1A